TOOLS - Kinergo

GT 01.100 | Valve body test machine VВTM-K

Price: On request
Check the price
  • Power, kW

    7,2

  • Weight, kg

    300

  • Dimensions (L x W x H), mm

    1230 x 850 x 1500

  • Relative humidity, %

    30-80

  • Voltage, V

    230/400

The test method is based on comparing the product under test with a known-good product's test results. To ensure high measurement accuracy, a modern, multi-channel, high-speed controller of our own production is used.

The machine imitates the operating conditions of a valve body in a vehicle.

Using the regulator, you can change the inlet pressure, replicating the operation modes of the automatic transmission pump at different engine speeds. To start testing, the following conditions are required to be set beforehand: temperature, inlet pressure, and the selection of a scenario (solenoid control algorithm).

Stages:

After starting the scenario, the stand will automatically start to control solenoids and simultaneously read pressure and current from all control channels in use.
At the end of the test, the data collected is presented in the form of graphs.
Using the intuitive software, the operator can select the analysis method that suits him best by switching the graphs from the normal view to the hysteresis view. Finally, the operator compares the results obtained from the test with the master graphic charts pre-loaded into the system and gives a conclusion.

The sequence of work is as follows:

1. Mount the valve body to the adapter plate, connect both hydraulic hoses and electrical wiring in accordance with the attached diagram.
2. The stand must be preheated to the required temperature. Select the scenario. Set the required inlet pressure according to the pop-up prompts.
3. Start the automatic test procedure, if necessary, switch the manual valve to the required positions and await results.
4. Analyze the data collected from the test, and give a conclusion on the condition of the valve body.

Test plates and cables for VBTM-K

TOOLS

Categories
Image
Description
Number detail
Quantity to order
1

The PTPN01 Tray for plungers will help to put all the devices in one place and keep a neat in the workplace. Suitable for the VTM-K hydroblock diagnostic stand. The tray is made of steel, which provides durability. 

2

The PTPN02 Tray for plungers will help to put all the devices in one place and keep a neat in the workplace. Suitable for the VTM-K hydroblock diagnostic stand. The tray is made of steel, which provides durability. 

3

Drain Valve 97000
An additional device for the VBTM-K valve body diagnostics stand, designed to circulate the working fluid of one of the channels of the tested valve body (Release / Apply).
Eliminates the problem of blocking the working fluid in the channels of the valve body during the operation of the stand, which allows the testing procedure to be carried out in the modes as close as possible to the operational modes.
It is plugged in the connector of the output hydraulic channel of the adapter plate.